3-axle trailer The HTD

The standard

Rugged, reliable, economical
i

Drawbar with 8° inclined towing ring Ø 40 mm, height-adjustable silent bushes.

i

Solid welded construction of turntable with large slewing ring

i

Solid, welded frame made of high-strength, fine-grained steel and full-length cross-beams for maximum stability, wheel recesses above the rear wheels, front corners chamfered, climbing rails on the ramp at the back for maximum safety during loading and unloading. Straight or cranked cargo bed. 

i

Chassis and attachments are hot-dip galvanised in an immersion bath, optional excavator-style stacker.

i

Floor made of 50 mm softwood planks. 

i

5 pairs of 10 t lashing points recessed in the platform floor.

i

Air suspension aggregate that can also lift and lower the rear axle.

i

Single-section, hot-dip galvanised drive-on ramps, laterally movable, directly acting, fixed spring lifters for convenient operation, optimally secured by a turnbuckle and latch. 

i

Flatbed axles with closed drum brake.

i

EBS braking system, spring-loaded parking brake.

i

Light clusters, impact-proof and secured against vibration, protected in the underride protection, 24 V, 15-wire connection cable. 

i

Foldable lateral impact protection, contour markers at the sides and rear.

i
  • Front half-shell mudguard with anti-spray system in front,
  • steel mudguard with anti-spray system at the rear
i

2 wheel chocks with retainers.

A classic product – rugged, reliable, economical. The cranked cargo bed area serves as a stop for wheeled or tracked vehicles. The cargo rests against a stop and is easier to secure. You can reduce the already low load height even more by using a cargo bed which can be lowered by air-suspension.

Details of the HTD 3-axle cranked flatbed turntable trailer:

Drawbar
Solid, welded construction of the turntable
Solid welded frame
Optimal corrosion protection
Floor made of 50 mm softwood planks
5 pairs of tie-down rings
Air suspension system incl. lifting and lowering
Single-section, hot-dip galvanised drive-on ramps
Flatbed axles with closed drum brake
Braking system
Light clusters
Foldable lateral impact protection
Mudguard
2 wheel chocks with retainers

Technical data

HTD 308525-3A, offset

Permissible gross weight in kg 24000* / 30000** Body dimensions in mm 10780 x 2540 x 3780
Load capacity in kg 17600* / 23600** Drive-up angle 10 °
Internal dimensions in mm 6500 x 2520 Tyre size in inches 12-fach 235/75 R17,5
Load height in mm 890    

* Permissible gross weight for distributable load without special permit   ** Permissible gross weight for non-distributable load with special permit in accordance with § 70 STVO (German Road Traffic Act)
Subject to technical modifications. All specifications are approximate values and relate to a series vehicle without accessories. Additional equipment will change both the empty weight and the load capacity!

What can I transport with the Humbaur HTD trailer?

Mobile excavators and wheel loaders

Mobile excavators and wheel loaders up to a weight of approx. 17.6 to 23.6 tonnes, depending on the model.

Crawler excavator

Crawler excavator with a weight up to approx. 17.6 - 23.6 tonnes, depending on the model.